CORPORATE IDENTITYPROJECTSACTIVITIESCONSTRUCTION EQUIPMENTOUR SUBSIDIARIESREFERENCESHUMAN RESOURCES

       

WHAT IS ROBOCAM?

This is an electromechanical robot with 4 direction movement in horizontal, 360 degree monitoring and working skills in vertical.

PLACES OF USE

This is used in order to monitor waste water and rain water channels which could not be directly interrupted by people, and remedy any narrowing or clogging in the monitored channel.

TECHNICAL SPECIFICATIONS

This offers detailed information for the channel inside monitoring, such as meter, inclination, working angle target photo as well as quick and effective information, report and repair opportunities. It consists of two main units.

1-High resolution, clean, real time natural view
2-Repair unit
The electromechanical group within the repair unit carries out cutting, breaking, drilling and stroking for removal of foreign objects at variable (required) speeds and forces, safely and successfully. It provides user with the opportunity to see while intervening a failure.
3-There is an electronic protection within itself against the mechanical obstructions

MECHANICAL PROPERTIES

Working channel section: 300 mm, 400 mm, 500 mm, 600 mm
Nominal speed:
12 m/minute
Climbing inclination:
34.55°
Declining inclination:
38.53°

USE

ROBOCAM, with a very simple use, has two different operating modes:

1-Channel monitoring and reporting
2-Channel monitoring, use with cutter and reporting

1-CHANNEL MONITORING REPORT

Before operating the Robocam, new project entry is made in the software. Here, the data related to the channel to be processed are entered. After this, the Robocam is ready to enter into the channel. The system is opened at the Control Panel. Assisted by the functions here, the Robocam is sent into the channel. The process follow up is very easy in the system where you continuously take views. At the end of the process, the Robocam is brought to the stack, via control panel function. With the assistance of a crane, it is re-placed in the vehicle. Then, the channel monitoring report in the computer software is completed and it is taken to the archive.


       

       

   

 

2-CUTTER ROBOT

At the time of this operation, differing from the operation no. 1, a cutter is used,. The problems within the channel are both monitored and remedied. The cutter use is also very easy. There are cutter related functions on the control panel.


       

       

       

       

 
 



Mesnevi Cd. Komşu Sok. No:1/5 Çankaya
Phone:+90.312 440 45 63 Pbx Fax:+90.312 438 74 55
info@akadinsaat.com